Metal injection molding car trunk lock seat titanium alloy MIM parts

Metal injection molding car trunk lock seat titanium alloy MIM parts

Schematic diagram of car trunk lock;

Different car manufacturers and different models have their own different methods for opening the trunk. The reasons and solutions for the trunk cannot be opened are as follows:

1. Linking rod or lock core problem

If you often use a key to open the trunk lid, it means that the connecting rod is broken. Go to the repair shop to open it. If you always use the remote control to open the trunk lid, the lock cylinder is dirty or rusty. Spray rust remover into the lock cylinder a few times to open it.

2. Not unlocked

There is no remote key to unlock, so it will be difficult to open. Before opening, it is best to press the key's opening button or check if the key battery is discharged.

3. Body parts failure

There is a problem with the trunk itself. For example, the trunk wire is broken or other trunk reasons prevent the car trunk from opening.

4. Five-door cars generally cannot be opened from the inside.

Like some hard-core off-road vehicles, in order to prevent accidentally touching it while driving, which may cause casualties, generally there is no trunk switch in the car, so it can only be opened outside the car.

Emergency opening method

If the trunk switch fails and cannot be opened with the key. We can use an emergency opening method. There will be a small card slot inside the trunk of most models. You can use a key or other sharp object to pry open the upper shell. After the shell is pried open, you can see the rear trunk locking mechanism inside. You can easily open the door by simply pulling it with your hand. Of course, this situation is rarely encountered. Even if there is a fault, we still recommend going to the maintenance point for repair first.

Qinhuangdao Zhongwei Precision Mechanical Parts Co., Ltd. was established in 1997 and is a metal powder injection molding (MIM) product manufacturer and solution provider. We provide customers with large quantities of various metal material structural parts, functional parts and appearance parts with high precision, complex shapes, good performance and exquisite appearance. We also have the development capabilities of ceramics and titanium alloys to meet the needs of different types of customers. The company takes "intelligent manufacturing and excellence" as its development goals.